We did not find any results

Stop a Campaign Sent by Mistake

If you started a newsletter campaign by mistake, act quickly. The procedure below follows the campaign-management demonstration in the original Pulseem guide.

1. Find the original campaign

Open Newsletter → Campaign Management. Locate the campaign by name and campaign number, and check its status. In the demonstration, the original campaign is marked Sending.

2. Keep a draft copy

Click Duplicate on the original campaign. Review the settings in the duplication dialog and confirm. The demonstration leaves the optional settings unchecked and creates a separate draft copy. Keep this copy as a draft; do not send it.

3. Delete the original campaign to stop its remaining delivery

Identify the original campaign again, using its campaign number and Sending status so you do not confuse it with the new draft. Click Delete on the original campaign and confirm the deletion. Wait for the success message.

4. Verify cancellation in the reports

Open Reports → Email and locate the original campaign. Confirm that it is marked Cancelled, then check the number of messages already sent. If cancellation is not shown, contact Pulseem support before assuming that delivery has stopped.

What cancellation can and cannot do

Stopping a campaign does not recall messages that have already been delivered. The number already sent depends on when you cancelled it. Review and correct the draft copy before considering a new send.